 |
BionX PL350 Kit: 350 Watt Motor with 36 Volt Lithium Battery - $1595
Highlights
- Motor: 350 Watts - 8.8 lbs
- Battery: 36 Volt 9.6 Ah - 8.2 lbs
- Total Kit Weight: 17 lbs
- Max Assisted Speed: 20 mph
- Charge Time: 4 Hours (Battery Also Can Be Charged While Braking or Downhill)
- Battery Life: 800 Complete Cycles
- Easy To Use: Activated by pedaling with 4 Assistance Levels and Thumb Throttle Control
- Free Gearing, Cone Tool & Help: Call our Toll Free number, 1-888-540-2283 for assistance!
- Max Assisted Speed: 20 mph
BionX Maximum Range Per Electric Assist Setting
| Setting: |
1 |
2 |
3 |
4 |
| NiMH 250 |
43 Miles |
28 Miles |
22 Miles |
15 Miles |
| Lithium 250 |
50 Miles |
40 Miles |
25 Miles |
18 Miles |
| Lithium 350 |
62 Miles |
46 Miles |
34 Miles |
28 Miles |
Command Console
Power-Assist: Controls the 4 assistance levels. The analog display indicates the power supplied by the battery.
Generation: Controls the 4 generative settings. The analog display indicates the energy transmitted to the battery.
The console includes a multifunctional odometer that displays the following information: Current speed, Trip Meter, Odometer, Chronometer, Average speed, Time. The battery charge indicator helps you manage the battery charge in order to prevent running out of energy on the return trip. The console also includes an alarm system with a 4-digit PIN (personal identification number). When the alarm system is activated, two wheel turns are enough to set it off. From that moment, the motor goes into generative mode 4 and the alarm sounds.
350 Watt Motor
350 W nominal at 700 W peak. Nominal torque: 10 N.m , Maximum torque: 32 N.m, 4 power-assist levels: The strain gauge allows the BionX motor to measure the rider's effort and boost the thrusting power by 25%, 50%, 100% or 200%, according to the selected assist level. Weight: 3.5 kg/7,7 lb. External case material: Aluminum, Four regenerating levels: The battery can be recharged while riding downhill or upon braking. Safety: The motor is completely sealed so you can ride your bicycle in the rain and a thermal protection prevents any overheating.
Battery
The battery is installed on a rail using the water bottle holes allowing you to install and remove your battery within 5 seconds. No other battery can be installed/removed so easily. It is also possible to install the battery on a back carrier. The BionX system includes a specific charger for each batter that detects and stops charging when the battery is full. At all times you know if the charger is still charging or if the charge is complete. NiMH battery charger (1.8 Amp/h): recharges in approximately 3 hours, if it is completely uncharged or not. It is also possible to recharge the battery while riding downhill or while braking.
|
Call for a free test ride today!
303-363-6887 or 1-888-540-2283
|
I-70 and E-470 (DIA Area), Aurora, CO. 80018 :: Tel# 303.363.6887 :: Toll Free# 888.540.2283
|
|
